Intelligent-motion-systems UDAS-1001E Manual de usuario descargar pdf (Pagina 62)

C-7

Analog Output Channel 0 Offset and GainAnalog Output Channel 0 Offset and Gain

1. Verify the termination panel is attached to a 50-pin connector of a UDAS unit. Begin with step

2 if the unit has built-in termination.

2. Attach a multimeter to analog output channel 0.

3. Use SYSCHECK or other software to set analog output channel 0 to -10.000 V.

4. Adjust Pot R26 for -10.000 V (±0.2 mV).

5. Set analog output channel 0 to 9.9951 V.

6. Adjust Pot R36 for 9.9951 V (±0.2 mV).

7. Repeat these steps to verify the results.

Analog Output Channel 1 Offset and GainAnalog Output Channel 1 Offset and Gain

1. Verify the termination panel is attached to a 50-pin connector of a UDAS unit.

2. Attach a multimeter to analog output channel 1.

3. Use SYSCHECK or your calibration software to set analog output channel 1 to -10.000 V.

4. Adjust Pot R24 for -10.000 V (±0.2 mV).

5. Set analog output channel 1 to 9.9951 V.

6. Adjust Pot R25 for 9.9951 V (±0.2 mV).

7. Repeat these steps to verify the results.

1 2 ... 57 58 59 60 61 62 63 64 65

Sin comentarios

Intelligent-motion-systems UDAS-1001E Manual de usuario Pagina 62